Herunterladen Inhalt Inhalt Diese Seite drucken

Initial Use; Inserting / Replacing The Batteries - Silvercrest SPWS 180 E1 Bedienungs- Und Sicherheitshinweise

Sprechende personenwaage
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 54
open them. Overheating, fire or
bursting can be the result.
Never throw batteries / recharge-
able batteries into fire or water.
Do not exert mechanical loads to
batteries / rechargeable batteries.
Risk of leakage of batteries /
rechargeable batteries
Avoid extreme environmental
conditions and temperatures,
which could affect batteries /
rechargeable batteries, e.g.
radiators / direct sunlight.
If batteries / rechargeable batter-
ies have leaked, avoid contact
with skin, eyes and mucous mem-
branes with the chemicals! Flush
immediately the affected areas
with fresh water and seek medical
attention!
WEAR PROTECTIVE
GLOVES! Leaked or
damaged batteries / rechargeable
batteries can cause burns on
contact with the skin. Wear
suitable protective gloves at all
times if such an event occurs.
In the event of a leakage of bat-
teries / rechargeable batteries,
immediately remove them from
the product to prevent damage.
Only use the same type of bat-
teries / rechargeable batteries.
8
GB/CY
Do not mix used and new batter-
ies / rechargeable batteries.
Remove batteries / rechargeable
batteries if the product will not
be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before
inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.

Initial use

Note: Remove all packaging materials from the
product.
Inserting / replacing the
batteries (see Fig. F)
1. Turn the product over and place it on a soft
underlay to avoid scratching the surface.
2. Open the cover of battery compartment
the back of the product.
3. Remove the used batteries, if present.
Note: The LC display
replace the batteries. When standing on the
at
6
will show then to
1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis