Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Display reverse
To invert the display by 180°, press the UP or DOWN button so many times until dISP is indicated in the
display. Confirm with the ENTER button. Use the buttons UP and DOWN to select the option On or oFF.
Select On to invert the display and oFF to return to the default setting.
Indicate temperature
To indicate the internal temperature of the device, press the button UP or DOWN so many times until temp
is indicated in the display. Confirm with the ENTER button. The temperature will be indicated in the display.
Indicate working hours
To indicate the status of the operating hours counter, press the button UP or DOWN so many times until
FhrS is indicated in the display. Confirm with the ENTER button. The operating hours will be indicated in the
display.
Indicate software version
To indicate the version number of the firmware (operating system of the unit), press the button UP or DOWN
so many times until ver is indicated in the display. Confirm with the ENTER button. The version will be
indicated in the display.
Reset to default settings
The device can be reset to default settings. Press the UP or DOWN button so many times until deFA is
indicated in the display. Confirm with the ENTER button.
Interconnecting
several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1
Configure all slave units before connecting the master unit: Press the UP or DOWN button so many
times until SLnd is indicated in the display. Confirm with the ENTER button.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3
Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
27/32
00125480, Version 1.1
Werbung
Inhaltsverzeichnis
