Videotec VERSO Bedienungslanleitung Seite 12

BOARD DESCRIPTION (VERSO, VERSION WITH DOUBLE
FILTER FOR AIR RENEWAL)
Connector Function
J1 Board power supply (V
J2 Auxiliary output (V
J3 Heater power supply (V
J4 Tamper switch contacts3
J5 Camera power supply (V
J7 Power supply connector/jumper5
J8 Fan power supply (V
SW1 Tamper switch3
Tab. 2 From 100Vac to 240Vac, 24Vac or12Vdc.
1
Same voltage applied to power supply terminal of the
2
board (J1).
Optional.
3
Different alternatives are available depending on the
4
version. V = 12Vdc or V
OUT
type of power supply installed (7.2.1 Camera power
supply installation, page 12). V
sings powered in 12Vdc or 24Vac, with jumper inserted
(J7).
To install a power supply in 12Vdc or 24Vac refer to the
5
relative chapter (7.2.1 Camera power supply installa-
tion, page 12).
J5 J3
J4 J1 J2
Fig. 5 VERSO (version with double filter for air renewal).
10
)1
IN
)2
OUT
)
OUT
)4
OUT
)
OUT
= 24Vac, in relation to the
OUT
= V , only for hou-
OUT IN
J7 SW1
J8
BOARD DESCRIPTION (VERSO POLAR)
Connector Function
J1, J2, J3 Heater power supply (V
J6 Camera power supply (V
J7 Board power supply (V
J8 Power supply connector/jumper3
J10 Auxiliary output (V
Tab. 3
Different alternatives are available depending on the
1
version. V = 12Vdc or V
OUT
type of power supply installed (7.2.1 Camera power
supply installation, page 12). V
sings powered in 12Vdc or 24Vac, with jumper inserted
(J8).
From 100Vac to 240Vac, 24Vac or12Vdc.
2
To install a power supply in 12Vdc or 24Vac refer to the
3
relative chapter (7.2.1 Camera power supply installa-
tion, page 12).
Same voltage applied to power supply terminal of the
4
board (J7).
J6
J10 J7 J1 J2
Fig. 6
VERSO POLAR.
)
OUT
)1
OUT
)2
IN
)4
OUT
= 24Vac, in relation to the
OUT
= V , only for hou-
OUT IN
J3 J8
MNVCHPVB_1351_EN