Installation; Appliance Positioning; Unpacking - AEG LAVATHERM 71270AC Benutzerinformation

12. INSTALLATION

12.1 Appliance positioning

• The tumble dryer must be installed in
a clean position, where dirt does not
collect.
• Air must flow freely around the appli-
ance. Make sure that the front airflow
slots in the bottom of the appliance
are not blocked .
• To keep vibration and noise at the
minimum, when the tumble dryer op-
erates, it must be put on a stable and
flat surface.
• When the appliance is put in its per-
manent position, check if is fully level
with the aid of a spirit level. If it is not,
adjust the feet until it is.
• Do not remove the feet. Do not de-
crease the floor clearance through
thick carpets, bar of wood or equiva-
lent. This can increase the heat which
can cause interference with the opera-
tion of the appliance.
• The temperature of the hot air
• When the tumble dryer oper-
• If it is necessary to move the
• The appliance must not be in-
It is possible to adjust the height of the
tumble dryer. To do that adjust the feet
(see picture).
which occurs in the tumble dry-
er can increase to 60 °C. The
appliance must not be instal-
led on the floor which is not re-
sistant to high temperatures.
ates, the room temperature
must not be lower than +5 °C
and higher than +35 °C. This
can cause unwanted effect on
the performance of the appli-
ance.
appliance, it must be moved
vertically.
stalled behind a lockable door,
a sliding door, a door with a
hinge on the opposite side to
that of the appliance in such a
way that a full opening of the
tumble dryer is restricted.
15mm

12.2 Unpacking

CAUTION!
Before use all parts of the transport
packaging must be removed.
To remove the polystyrene blockages:
1. Open the load door.
2. Pull plastic hose with the polystyrene
blockages out from the drum.
12.3 Installation under a
counter
The appliance can be installed as free-
standing or below the kitchen counter
with correct space (see picture).
ENGLISH
83