Installation Notes; Temperature Adjustment - Klarstein Berghain Bedienungsanleitung

INSTALLATION NOTES

It is important that upon receipt you stand your appliance upright for at least 4 hours
before switching on to allow the system to settle.
• The appliance should not be tilted more than 45 degrees when you move it. Do not
use force on any part such as the condenser, the door or handle. They could distort
and affect the operation of the cooler. Ensure ALL packaging is removed before
installation.
• Make sure there is enough ventilation space around product.
• The appliance should not be installed near external heat sources e.g. direct sun
shine or external moisture sources.
• Ensure the supply voltage of socket is same as rating label.
• The plug must be properly inserted to the wall socket.
• The mains supply socket must be earthed - preferably with a switch. If it is not
earthed, do NOT install this appliance there. Do not use an extension cord.
• The product is equipped with adjustable feet. Once the product is in place, adjust
these to ensure the fridge is level and doesn't rock.
Note: Do not site the product where the ambient temperature is likely to drop below
5 °C - e.g.: garage or shed.

TEMPERATURE ADJUSTMENT

• The internal temperature is maintained at level 4-5 at approx. 0-1 °C with full
filling.
• If the ambient temperature or the internal filling quantity is extremely high, this may
lead to a slightly higher internal temperature. In this case, turn the thermostat to the
right to reduce the temperature.
• If the ambient temperature or the internal volume is very low or the refrigerator is
empty, the internal temperature may reach below 0°C and cause ice to form on the
evaporator. In this case, turn the thermostat to the left to increase the temperature.
Defrost note
Defrosting takes place automatically and the effluent water is collected in the collection
tray. The water in the drip pan evaporates automatically. When the air humidity is high,
a large amount of water may accumulate in the drip pan. In this case, you must dispose
of the collected water manually.
EN
15