Front Panel Controls; On/Off Switch; Source Selection - T+A P 3000 HV Betriebsanleitung

All the important functions of the P 3000 HV can be controlled using the sensor buttons and rotary knobs on the front
panel. The large rotary knobs are used to select the listening source and adjust the volume. Functions which are needed
less frequently are controlled using a menu which is called up by pressing the
All information pertaining to the machine's status is displayed on the integral screen. The following explains in greater
detail the functions of the front panel buttons and the meaning of the on-screen information.
 On / Off switch



 Source selection
SOURCE
34

Front panel controls


Touching the button briefly switches the device on / off.
 
The button remains dimly lit even in stand-by mode, to indicate that the
P 3000 HV is ready for use.

Caution!

The mains button is not an isolation switch. Certain parts of the machine remain
connected to mains voltage even when the screen is switched off and dark. If you
know you will not be using the machine for a long period, we recommend that you
disconnect it from the mains by withdrawing the mains plug from the wall socket.
The desired listening source is selected by turning this rotary knob; your chosen
source then appears on the screen. After a short delay the machine switches to
the appropriate source.

It is possible to assign individual names to the listening sources.
(see Chapter 'Basic settings of the P 3000 HV')

button.