Safety And Installation; Operator Safety - Techne IFB-51 Bedienungsanleitung

SaFety anD InStallatIOn

Please read all the information in this booklet before using the unit.
WarnIng
HIGH TEMPERATURES ARE DANGEROUS: they can cause serious burns to operators and ignite
combustible material.
Techne have taken great care in the design of these units to protect operators from hazards, but
Operators should pay attention to the following points:
• USE CARE AND WEAR PROTECTIVE GLOVES TO PROTECT HANDS.
• DO NOT put hot objects on or near combustible objects.
• DO NOT operate the unit close to inflammable liquids or gases.
• DO NOT place any liquid directly in your unit.
• At all times USE COMMON SENSE.

OperatOr SaFety

All users of Techne equipment must have available the relevant literature needed to ensure their safety.
It is important that only suitably trained personnel operate this equipment, in accordance with the
instructions contained in this manual and with general safety standards and procedures. If the equipment
is used in a manner not specified by Techne the protection provided by the equipment to the Operator
may be impaired.
All Techne units have been designed to conform to international safety requirements and are fitted with
an overtemperature cutout. On some models, the cutout is adjustable and should be set to suit the
application. On all other models the cutout is preset to protect the unit.
If a safety problem should be encountered, switch off at the mains socket and remove the plug from the
supply.
InStallatIOn
This Techne Industrial Fluidised Bath (IFB) is designed to be operated as a permanently connected piece
of equipment and must be installed by a fully qualified electrician with experience of installing 3 phase
equipment.
The IFB must be installed with an appropriately rated switch and/or circuit breaker included in the
building installation.
The switch or circuit breaker should be in close proximity to the IFB and within easy reach of the
operator.
The switch or circuit breaker should also be clearly marked as the disconnecting device for the IFB.
2