Specifications - Makita AN250HC Bedienungsanleitung

ENGLISH (Original instructions)
4-1. Adjuster
5-1. Too deep
5-2. Flush
5-3. Too shallow
6-1. Screw
6-2. Hook
7-1. Contact element
7-2. Nose adapter

SPECIFICATIONS

Min. hose diameter
Dimensions (L X W X H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
Intended use
The tool is intended for securing a thin steel plate to the
concrete.
Noise
The typical A-weighted noise level determined according
to EN792:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration emission value determined according to
EN792 :
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
Explanation of general view
8-1. LOCK position
9-1. FREE position
10-1. Latch lever
11-1. Door
11-2. Driver channel
14-1. Trigger
14-2. Contact arm
14-3. Workpiece
Model
Air pressure
Nail length
Nail capacity
Net weight
) : 89 dB(A)
pA
) : 102 dB(A)
WA
2
) : 3.5 m/s
h
2
END105-2
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENE072-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENG102-3
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
ENG233-2
machine(s):
Designation of Machine:
Pneumatic Concrete Nailer
Model No./ Type: AN250HC
are of series production and
ENG901-1
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
EN792
4
15-1. Thin steel plate
15-2. Penetration amount into concrete
20-1. Cap
21-1. Drain cock
22-1. Air filter
23-1. Oiler
23-2. Pneumatic oil
AN250HC
1.18 - 2.26 MPa (11.8 - 22.6 bar)
19 mm - 25 mm
Sheet-collated coil pin
100 pcs
5 mm
295 mm X 128 mm X 291 mm
2.1 kg
Corporation as
ENH003-11
the responsible