Invacare HomeFill HF2RE9 Benutzerhandbuch Seite 18

SECTION 4—INSPECTION AND COMPRESSOR INTERFACE
Disconnecting the Cylinder from the Compressor
NEVER use tools of any kind to connect/disconnect the cylinder
and the compressor. Otherwise, severe injury and/or damage may
occur.
NOTE: For this procedure, refer to FIGURE 4.5, FIGURE 4.6 on page 19 and
FIGURE 4.7 on page 19.
1. Press the compressor power switch to the Off "O" position.
2. Grasp the cylinder/regulator assembly in the area behind the cylinder
contents gauge (FIGURE 4.5).
3. With the other hand, grasp the outer ring (sleeve) of the connector
fillport and push DOWN (FIGURE 4.5).
4. Lift up on the cylinder/regulator assembly to remove from the
connector fillport (FIGURE 4.5).
Cylinder
Contents
Gauge
Compressor
Connector Fillport
FIGURE 4.5 Disconnecting the Cylinder from the Compressor
5. When the cylinder fillport is disconnected from the connector fillport,
release the outer ring (sleeve) of the connector fillport and use two
hands to remove the cylinder from the compressor cradle.
HomeFill
®
WARNING
Cylinder/Regulator
Assembly
Cylinder
Fillport
18
PUSH DOWN
Outer Ring
(Sleeve)
Part No 1167426