Kemppi Flexlite GX Serie Bedienungsanleitung Seite 13

>> With K8 level Flexlite GX models, see also the note at the end of this section.
3. If you are replacing an existing wire liner with a new one, remove the old wire liner from the cable hose.
If you still plan to use the same wire liner later, make sure not to damage the wire liner at this stage.
4. Feed the new wire liner into the cable hose until it stops at the gun neck end.
To ensure that the wire liner is in the correct position, temporarily remove the welding gun contact tip. For more
information on the contact tip, refer to "About equipment" on page 6 and "Assembling gun" on page 9. In case of a
multi-neck welding gun, the wire liner does not go into the neck. With a multi-neck welding gun, the neck is to be
removed (refer to "Installing and replacing wire liner for multi-neck" on page 16).
5. Insert the cone and the liner sleeve without the short guide tip on the wire liner. Secure them by tightening the
liner sleeve.
Tip: The wire liner needs to be cut exactly at the edge of the liner sleeve. To get the best possible result,
mark and cut the wire liner already before securing the liner sleeve.
© Kemppi
14/49
Flexlite GX
Operating manual - EN
1921390 / 2002