Preface, Technical Data, Mounting Of Room Temperature Unit, Room Temperature Unit, Display - LK Armatur SmartComfort RTW Bedienungsanleitung

GB ENGLISH
Preface
Installation and maintenance must be carried out by technically
qualified personnel. All instructions in this manual should be read
and understood before starting any work with the SmartComfort.
For safety reasons, no modifications or amendments are allowed.
Warning!
Before starting installation work, the power supply
must be disconnected. Make sure to adhere to valid
safety regulations.
Technical Data
Operating temperature
Shipping and storage temperature -10°C to 50°C (14°F to 122°F)
Setting temperature range
Electrical protection
Batteries
Frequency
Room temperature unit SmartComfort RTW
The room temperature unit is equipped with an antenna
for wireless communication between actuator and room
temperature unit, batteries and a table top stand for the
room temperature unit.
Connect the antenna to the socket marked
tuator.
Connection for antenna
Mounting of Room Temperature Unit with
LK 120 or LK 130 SmartComfort
The room temperature unit should be mounted at a place that has
an average temperature of the house. For optimal performance ra-
diator thermostats in the room where the temperature unit is in-
stalled should be set in fully open position.
Important! The room temperature unit is neither splash- nor
drip-proof, therefore it must be mounted at a dry place. It
must not be placed where it can be affected by direct sun-
shine, heat radiation or draught.
A suitable place is an inner wall in the living room about 1.5 m above
the floor. See mounting picture.
To ensure good air circulation a spacer ring should be placed be-
tween wall and room unit. An opening for the cable is made with
a suitable tool.
1,5 m
20 cm
Interference may occur if the antenna is placed on metal, metal piping, too
close to other wireless devices or power cables. The antenna must not be
too close to the room temperature unit during start-up.
0°C to 40°C (32°F to 104°F)
5°C to 37°C (41°F to 99°F)
Class III – IP 20
2 pcs AAA alkaline batteries
868 MHz
on the ac-
Room Temperature Unit
Minus (-)
Left
Escape
Cover for navigation,
escape and edition keys
Display
1 2
13
12
11
1.
Remote control e.g. via mobile phone.
2. Keyboard's lock function
3. Operating mode
4.
Boost function –Temporary power boost when raising the
temperature setting
5.
Program number
6. Service mode
7.
Room temperature ,
8. Temperature
9. °C or °F indicator
10. Program of the current day (the current time bar blinks)
11. Clock
12.
Symbol for reduced temperature,
13. Current day (1=first day of the week)
14.
Communication symbol
antenna communicate.
15.
Battery indicator , shown when batteries are low. Change bat-
teries! The programs are saved. Time and date have to be set.
Terminal block for GSM remote control
Display
Plus (+)
Confirmation
OK
and LED-
indication
Right
Edition
3 4
5
6
7
14
15
%
9
10
8
Outdoor temperature
or
, blinks when room unit and
3