D- 42327 Wuppertal; Nico Kowalski, Walther Spritz- Und Lackiersysteme Gmbh, Kärntner Str - WALTHER PILOT PILOT 2K Betriebsanleitung

Table of contents
Explosion drawing
Declaration of conformity
Listing of Replacement Parts
1 General
1.1 Model identification
1.2 Intended use
1.3 Unintended use
2 Technical description
3 Safety instructions
3.1 Identification of safety instructions
3.2 General safety instructions
4 Connecting supply lines and Operation
4.1 Generating a spray pattern test
4.2 Changing the spray pattern
5 Converting / repairing the spray gun
5.1 Replacing the material nozzle and air cap
5.2 Replacing the material needle (component A)
5.3 Replacing a leaking needle seal (component A)
5.4 Replacing the component B
5.5 Replacing the material nozzle (component B)
5.6 Replacing the material needle (component B)
5.7 Replacing a leaking needle seal (component B)
5.8 Correcting flaws of spray pattern
6 Cleaning
7 Troubleshooting and fault correction
8 Disposal
9 Technical data
2
19
20
23
23
23
23
24
24
24
24
25
26
26
26
27
27
27
28
28
28
28
29
29
30
30
31
18
EC/ EU Declaration of conformity
We, the device manufacturer, declare at our sole responsibility that the product with the
description below corresponds to the relevant based safety and health requirements. In
the event of changes to the device not agreed on with us or if used improperly this
declaration becomes invalid.
Manufacturer Walther Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Phone: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • email: info@walther-pilot.de
Type designation
Two-component hand spray gun
PILOT 2K Bonding
Wide jet
Round jet
Purpose of use Processing of sprayable materials
Applied standards and directives
EC Machinery Directive 2006/42/EC
EN ISO 12100:2011-03
DIN EN 1127-1:2011-10
Authorized to compile the technical documentation:

Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30

D- 42327 Wuppertal

Special notes:
The product is intended to be installed in another device. Commissioning is prohibited
until conformity of the end product with Directive 2006/42/EC has been verified.
Wuppertal June 28th, 2019
p.p.
Name: Torsten Bröker
Position in the company: Head of Design and Development
This declaration does not represent a promise of properties according to product liability. The safety instructions
of the product documentation must be observed.
V 11 820 0x xx3
V 11 821 0x xx3
19