Standard Equipment; Machine Assembly; Installing Wheels; Mounting Autofeed (Optional Accessory) - RIDGID K-400 Bedienungsanleitung

Motor:
Type ...........................115V/60 Hz, Reversible,
Split Phase
Rating......................... 1
Amps ..........................6.7
Weight (Machine Only)...45 lbs.
Length ..........................21"
24" w/AUTOFEED
Height ...........................23"
Width ............................17"
The K-400 Drain Cleaner AUTOFEED is protected under
U.S. and International patents including 6,360,397.

Standard Equipment

All K-400 Drain Cleaning Machines come with one pair of
RIDGID Drain Cleaning Gloves and a DVD showing K-400
use.
NOTICE This machine is made to clean drains. If prop-
erly used it will not damage a drain that is in good
condition and properly designed, constructed and main-
tained. If the drain is in poor condition, or has not been
properly designed, constructed and maintained, the drain
cleaning process may not be effective or could cause
damage to the drain. The best way to determine the
condition of a drain before cleaning is through visual in-
spection with a camera. Improper use of this drain cleaner
can damage the drain cleaner and the drain. This machine
may not clear all blockages.

Machine Assembly

WARNING
To prevent serious injury during use, follow these
procedures for proper assembly.
Belt Guard
Handle
Adjustment
Manual
Holder
Handle
Bumper
Front Bearing
Mount
Figure 1 – K-400 Drum Machine with
/ HP @ 1725 r/min
3
®
FWD/OFF/REV Switch
Drum
Cable
GFCI
Foot Switch
3 / " Cable and Tools
8
K-400 Drain Cleaning Machine

Installing Wheels

1. Install retaining clip into groove on one end of axle.
2. Slide one wheel onto axle with the boss away from
the clip.
3. Fully insert axle into axle tube.
4. Slide second wheel onto axle, boss first.
5. Install retaining clip into groove.
Axle Tube
Figure 2 – Assembling Wheel
Mounting AUTOFEED
(Optional Accessory)
1. Screw handle into the AUTOFEED.
2. Place the mounting bracket onto the back of the
AUTO FEED. Bracket shaft must be inserted into the
center hole of the AUTOFEED while the two (2)
holes in the bracket must be aligned with the mount-
ing pins (Figure 3) .
Figure 3 – Placing Mounting Bracket Into AUTOFEED
3. Remove the two bolts and nuts holding front bearing
mount to frame. Keep bearing mount and drum in
place.
®
5