Connecting The Tamper Detector; Replacing The Infrared Cover - GE SB Series Bedienungsanleitung

8.

Connecting the tamper detector

1. Remove the tamper PCB at the bottom of the column.
2. Make the connection to the terminal block.
3. Reinsert the PCB into position, sliding it as far as you can, and taking care not to twist
the contact strip.
Caution: Do not connect the tamper PCBs in the modules.
9.

Replacing the infrared cover

Caution: Leave the modules' infrared covers off.
1. Engage the infrared cover in the grooves in the chassis with the help of the guide hoop
at the top of the column. (1)
2. Slide the cover upwards until it is stopped by the top plate. (2)
3. Close the cover against the bottom plate. (3)
4. Secure the cover with the fixing screw. (4)
5. Replace the clips that hold the infrared cover. (5)
1
3
2
8
4
5