LED indicators
orange LED on
green LED on and blue LED on
orange LED flashes slowly
blue LED flashes slowly
blue LED flashes 3 times fast, followed by a short
pause
blue LED on
green and blue LEDs flashing fast
green and blue LEDs flashing twice slowly, then blue
LED on again
Getting started
Connecting the adapter to the Hi-Fi equipment
Connect one end of the supplied RCA cable (C) to the AUDIO OUT L (6) and AUDIO OUT R (7) sockets of the
adapter and the other end to the RCA audio input of your Hi-Fi equipment. Alternatively you can use an optical
S/PDIF cable (not supplied) to connect the S/PDIF (8) socket of the adapter to the optical S/PDIF input (if any) of
your Hi-Fi equipment.
Switching the adapter on
Connect the adapter to the supplied power adapter (B) and then connect the power adapter (B) to an easily
accessible power socket. Toggle the power switch (12) located on the back panel of the unit to "ON". The green and
blue LEDs go on simultaneously. After initialising, the blue LED flashes slowly. The adapter is now in AP mode.
Establishing the Wi-Fi connection
There are 2 ways to connect the adapter (A) to the existing network of your router via Wi-Fi: either by pressing the
WPS button (5) or by downloading the "UNDOK" control app for free from the Apple
Google
®
Play Store. In both cases, when establishing the connection for the first time, make sure to place the adapter
(A) as close as possible to the router to achieve an optimum Wi-Fi signal transmission. Then install the adapter (A)
within the Wi-Fi signal range.
Please note that a maximum of 16 devices can be connected to a network.
Standby mode (network connection active)
Adapter is initialising
Updating software
AP mode, waiting for network connection
WPS mode, waiting for WPS signal from router
Adapter on, Wi-Fi connection OK
Wi-Fi connection fault
Maximum volume has been reached
SilverCrest SMRA 5.0 A1
®
App Store or from the
English - 13