Auro Installation - Samson Auro 3 Bedienungsanleitung

You can mount the Auro Series
speakers on a wall or ceil- speakers on a wall or ceil-
ing using the included metal ing using the included metal
mounting bracket. You can po-
sition the Auro speaker either sition the Auro speaker either
vertically or horizontally. In the vertically or horizontally. In the
vertical position you can direct vertical position you can direct
the sound left and right. In the the sound left and right. In the
horizontal position you can
direct the sound up or down. direct the sound up or down.
In figure 1, you can see the
installation for an Auro series installation for an Auro series
speaker mounted in the speaker mounted in the
horizontal position. Follow
the steps below to hang your the steps below to hang your
speaker. You can turn the logo speaker. You can turn the logo
by lifting the corner and twist-
ing 90 degrees. ing 90 degrees.
IMPORTANT NOTE: IMPORTANT NOT
Only licensed and insured professional sound contractors should install the Auro Only licensed and insured professional sound contractors should install the Auro
Speaker using the installation bracket. Samson assumes no liability for any instal- Speaker using the installation bracket. Samson assumes no liability for any instal-
lation. lation.
• Remove the ABS plastic insert on the top and bottom of the Auro speaker. • Remove the ABS plastic insert on the top and bottom of the Auro speaker.
• Mount the metal bracket on the wall or ceiling using the appropriate hard- • Mount the metal bracket on the wall or ceiling using the appropriate hard-
ware suitable for the building material you are attaching to.
• Slide the Auro speaker into the metal bracket keeping the ends of the • Slide the Auro speaker into the metal bracket keeping the ends of the
bracket inside the top and bottom bracket channels.
• Insert the thumbscrews through the mounting bracket and into the thread- • Insert the thumbscrews through the mounting bracket and into the thread-
ed inserts, then tighten the thumbscrew, but not all the way.
Important Note: Be careful to insert the thumbscrews straight and do not Important Note:
cross-thread the thumbscrews.
• Position the Auro to the desired angle, and then, fully tighten the thumb- • Position the Auro to the desired angle, and then, fully tighten the thumb-
screw.

Auro Installation

Figure 1
9