Installation; Installing The Tap; Operation; Bringing Into Use - lidl HG02578 Montage-, Bedienungs- Und Sicherheitshinweise

CAUTION! RISK OF DAMAGE TO
PROPERTY! Have the installation done by
experienced persons only. Leaks or escape
of water can lead to serious damage to
buildings or household fittings and furniture.
Check all connections for leaks carefully.
Ensure that all seals are correctly seated to
prevent leakage of water.
The spout can be swivelled to your desired
position. Make sure the spout is always
positioned within the area of the sink,
otherwise escape of water can lead to
serious flooding to your house or building.
CAUTION! DANGER OF SCALDING!
When making the hot water setting please
ensure that the temperature of the water is
not too high.
Before installation, make yourself familiar with
all the existing services, e.g. water connection
and stopcocks.
Please read carefully through these operating
instructions before installing and using
the product. Keep all the safety advice
and instructions in a safe place for future
reference!
§ Installation
§ Installing the tap
Turn off the main water supply to prevent
serious leakage of water. Allow any
remaining water in the pipework to drain.
Install the tap as shown in Figs. A to D.
m
CAUTION! Do not bend the hoses or place
them under tension. Otherwise material
damage could result.
6 GB/IE/NI
§ Flushing the tap
The tap must be flushed through before first use
to remove any dirt. To do this, follow these steps
(see Fig. F):
Screw the mixer nozzle
Open the main water supply and allow the
water to run for two minutes.
Then screw the mixer nozzle
§ Operation
§ Bringing into use
Note: If the fitting has not been used for a long
period flush the pipes through thoroughly in order
to avoid stagnation and build-up of residues in
the drinking water supply.
Open the main water supply.
Lift the control lever
right or left in order to regulate the speed or
temperature of the water flow.
Press the changeover switch
spray jet.
Press the changeover switch once more to set
to normal spray jet operation.
Check operation of the mixer. For this
purpose move the control lever
possible positions. Please regularly check all
connections to ensure that they are tight.
Pull the spray head down slightly and then
forward out of the holder to have freedom of
movement of the spray head when in use.
off.
10
on again.
10
and swing it to the
11
to set the
9
in all
11