Troubleshooting; Specifications - Gima DOMINO Betriebs- Und Wartungsanweisungen

17

TROUBLESHOOTING

SYMPTOM
No display when the
START button is
pressed.
Inflation stops and
reinflate later.
The reading is
extremely low or high.
Pulse rate is too low or
too high.
The batteries are run
down soon.

SPECIFICATIONS

Model: Domino
Size: 158(L) ×120(W) ×127(H)mm
Weight: Approximately 490g without batteries
Measuring method: Oscillometry
Measuring range: 40 to 260 mmHg (blood pressure); 40 to 160 beats/minute (pulse rate)
Measuring accuracy: ± 3 mmHg for systolic and diastolic pressure; ± 5% of the reading for the pulse rate
Inflation: Automatic by the pump
Rapid deflation: Automatic electronic valve
Batteries: 4"AA"×1.5V
Adapter: Optional component, 6V, 600mA
Memory: 2×60 sets of memories
Operation temperature and humidity: +10. to + 40, 85% and below
Storage temperature and humidity: -20. to + 50, 85% and below
Cuff size: Applicable for arm size 22-32 cm
Complete kit: Main body, storage case, cuff, 4×AA batteries(Optional),1xCR2025 button battery,
adapter(Optional), instruction manual, warranty card
CHECK POINT
The batteries have run down
The polarity of battery is wrong
The contact of battery compartment
is polluted
The automatic inflation for ensuring
correct measurement
Did you talk or move your arm (or
hand) during measurement?
Is the cuff at the same level as the
heart?
Is the cuff wrapped right?
Did you strain your arm during
measurement?
Did you talk or move your arm (or
hand) during measurement?
Did you talk or move your arm (or
hand) during measurement?
Did you make measurement right after
exercise?
Faulty batteries are used
ENGLISH
REMEDY
Replace all the batteries with new
ones.
Install the batteries correctly.
Clean the battery terminals with dry
cloth.
See<AUTOMATIC INFLATION>.
Keep quiet and silent during the
measurement.
Make sure that your posture is right.
Wrap the cuff correctly.
Relax during measurement.
Keep quiet and silent during the
measurement.
Keep quiet and silent during the
measurement.
Take measurement again after
resting for more than 5 minutes.
Use alkaline batteries of known
manufacturers.