Listening To The Fm Radio - Geneva M Bedienungsanleitung

How to adjust volume and sound?
1. Use the , , ,
control (or the touch panel wheel for the volume only) to adjust
sound and volume.
2. Volume: 0 means silence, 100 means maximum output.
3. Treble and Bass: -6 means very little Bass or Treble, 0 means
neutral, 6 means maximum effect.
4. If you turn the device off, the current values are stored.
2. Listening to the iPod
Step 1. To use the Geneva Sound System with an iPod, select
iPod as the audio source using the
under the grille should display "no iPod".
Step 2. Insert the correct iPod adapter: Attach the Dock Adapter
to the iPod Universal Dock by pressing lightly on the top of the
Dock Adapter (see picture) and it will snap in:
How to select the right iPod adapter for my iPod?
Use the iPod adapter provided with your iPod. Only if an
iPhone has to be docked, use the iPhone adapter provided
with the Geneva Sound System.
Step 3. Insert the iPod into the iPod dock. The display should now
show „iPod".
Step 4. Press the key on the remote control or on the Touch-
Light panel. If you still cannot hear any sound, check that the volu-
me is turned up by adjusting the
Step 5. You can control your iPod using the
on your remote control or the TouchLight controls on the system.
Step 6. The key on the TouchLight offers full control of the
iPod menu levels. Tap the menu key to navigate through iPod op-
tions. The TouchLight wheel is used to move up and down within a
menu. To select an item, tap the wheel.
Charging: Your iPod is charging while the system is connected to
an AC plug.
, , keys on the remote
or key: The display
key or the TouchLight wheel.
, , keys

3. Listening to the FM radio

Step 1. Select FM radio as the audio source using the
key on on the remote control or on the TouchLight; the display
under the grille should display an FM frequency, e.g. "103.2". If
you cannot hear any sound, check the volume setting by pressing
the key.
Step 2. Select an FM station with the
increases or decreases the frequency by 100 kHz. The number on
the display under the grille indicates the current frequency in MHz
(e.g. "88.7" on display means 88.7 MHz). Hold down the
the key and the FM radio will search for the next station au-
tomatically. When a station has been found, the automatic search
stops. To keep scanning, repeat this action.
How to switch between mono and stereo?
Press the button for 1 second to toggle between mono and
stereo mode.
How to store / recall a radio station (presets)?
1. Select your favorite radio station using the
the remote control or on the TouchLight.
2. Select one of the 6 preset keys on the remote control, and keep
pressing it until the corresponding letter on the display starts
blinking. The station has now been stored and can be recalled by
pressing the same preset key.
How to erase or overwrite a preset?
Stored presets do not need to be erased - just use the previous
steps to store a new station in a preset.
4. Using the Line Input
1. Use a cable with a 3.5mm jack to connect the Geneva Sound
System to any audio device that has an audio out connector.
First connect the cable to the source, then connect the cable
to the Line In connector located on the back panel of the
Geneva Sound System.
2. Switch the Geneva Sound System to Line in mode using
the on the TouchLight or
connected audio source. Note that you cannot control any
connected device using the Geneva Sound System remote
control, just the volume settings.
3. Adjust the output volume of the connected device.
5
or
and keys: one click
or
or keys on
key and activate the