Function Of Leds; Start-Up; Connection; Installation Of Operating System - Bosch KTS 670 Betriebsanleitung

en 22 | KTS ��� | Product description
�.5.�

Function of LEDs

On/Off (5) Function
Does not light up KTS 670 switched off
Lights up green KTS 670 switched on
Flashes green KTS 670 in standby mode
Hard disk access (8) Function
Does not light up No access to hard disk
Lights up red Hard disk access reading or writing
KTS 670 switched on or in standby mode:
Ext. supply (�) Function
Does not light up Internal voltage supply
(battery operation)
Lights up green External voltage supply
and battery charge state > 80 %
Flashes green External voltage supply
and battery charge state < 80 %
Battery (�) Function
Does not light up External voltage supply
Lights up orange Internal voltage supply
(battery operation)
Flashes orange Internal voltage supply
(battery operation)
and battery charge status < 20%
KTS 670 switched off:
Ext. supply (�) Function
Does not light up No External voltage supply
Lights up green External voltage supply
Battery (�) Function
Flashes orange Battery is charged by
external voltage supply
Via power pack or diagnostic cable.
1)
The battery charge state is displayed in the menu "
2)
control Energy options
>>
Additional warning signal, see chapter 5.5.3
3)
If the KTS 670 was switched off with an external voltage supply
4)
and battery charge state > 80 %, the battery is charged and the
LED battery does not flash.
|
1 689 989 017 2008-07-04
1)
2)
1)
2)
1)
2)3)
1)
1)
4)
System
Energy display
>> ".
4.

Start-up

4.1

Connection

Make sure before starting up for the first time that the
mains voltage matches the voltage specified on the
power pack (use mains connecting cable included).
i
The delivery specification only includes the German
mains connecting cable.
4.2

Installation of operating system

1. Connect power pack
After switching on for the first time, select the
2.
language of the Windows operating system via
the language selection menu and following the
instructions on the screen.
i
It is not possible to subsequently change the
language. However, should this be necessary, please
contact your Bosch authorized dealer.
3. After installing the operating system, the
touchscreen needs to be adjusted. For adjustment,
follow the instructions on the screen.
"
The KTS 670 remains in the start screen
Software Selection" after starting the system. This start
screen will always be displayed after switching on.
i
Before you can operate ESI[tronic], you must first
release the software. To this end please note the
ESI[tronic] "ESI[tronic]-Setup & Installation" operating
instructions included as part of the starter package.
4.� notes on Windows Control Panel
(Control panel)
On the KTS 670, the "Control panel" menu can be found
in the Windows start menu under "Programs" and not
as usual under "Settings". When calling up the "Control
panel" you will receive a warning with the message that,
under certain circumstances the device will no longer
work properly, if you change certain parameters.
i
Changes in the menus of
to the device no longer functioning properly. Repairs
resulting from this will be chargeable.
"Diagnostic
"Control panel" can lead
Robert Bosch GmbH