Dmx512 Control; Via Dmx-Cable; Via Quickdmx - EuroLite TL-3 TCL Bedienungsanleitung

DMX512 CONTROL

Via DMX-cable

DMX Controller
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1 Connect the output of your DMX controller to the DMX input DMX IN of the light set with a DMX cable.
2 Connect the DMX output DMX OUT of the light set to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3 At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4 If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
XLR connection:

Via QuickDMX

Connect the transmitter to the DMX controller. Set each transmitter and the AKKU TL-3 TCL Trusslight
QuickDMX into operation. Press the function switch to activate QuickDMX.
The QuickDMX status indicator shortly flashes red, green and blue. Afterward, it lights permanently
according to the selected transmission channel.
Set each transmitter and receiver to the same transmission channel. For this purpose, shortly press the
button "ID" on the device.
The selected transmission channel is indicated by the status indicator.
Channel Color
1 Red
2 Green
3 Blue
4 Yellow (red/green)
5 Cyan (green/blue)
6 Magenta (red/blue)
Device 1
Start Address 1
Program
Chase32 Step100
Device 2
Start Address 9
28/40
Device 3
Start Address 17
00125583.DOCX, Version 1.1