Grundig GKI 1120 B Handbuch Seite 32

Maintenance and cleaning
S
P
32
Clean the brewing unit under running tap wa-
ter without using detergent. Never clean the
brewing unit in the dishwasher.
Do not use washing up liquid to clean the
brewing unit. It would remove the lubricant
applied to the inside of the piston.
5. S oak the brewing unit in water for about 5
minutes, then rinse.
6. A fter cleaning, replace the brewing unit (L) by
sliding it onto the internal support (S) and pin
(P) at the bottom, then push the PUSH symbol
fully in until it clicks into place.
N.B.! If the brewing unit is difficult to insert,
you must first adapt it to the right dimensions
by pressing it forcefully from the bottom and
top.
7. O nce inserted, make sure the two colored
buttons have snapped back out, otherwise
the service door cannot be closed.
– The two colored buttons are correctly snapped
out (A).
– The two colored buttons are not snapped out
(B).
8. R eplace the drip tray and waste coffee
container.
9. C lose the service door.
Notes
• If the brewing unit is not put in place correctly,
the service door cannot be closed.
• If it is difficult to insert the brewing unit, it
must be made into the right height (before
inserting) by pressing the brewing unit firmly
A
together from top and bottom.
• If it is still difficult to insert the brewing unit:
– Leave it out of the appliance, place the drip
tray, close the service door, switch the main
switch on the back of the appliance to 'off' and
then to 'on' again.
B