Measuring Lengths; Single Measurement Mode - Parkside PLEM 50 A1 Bedienungs- Und Sicherheitshinweise

Measuring lengths

Single Measurement mode

1. Place or hold the reference plane of the device on or against
the desired base surface from which you want to determine a
distance.
2. Check the flatness of the device by use of both the bubble lev-
els . One of the bubble level is for checking horizontal flat-
6a
ness and the other air bubble is for checking vertical flatness.
To, check the flatness of certain angle, make sure that bubble
is positioned at the middle of respective angle bubble level.
3. Briefly press the MEAS button
the laser is switched on, it is indicated by the laser icon
the display.
Note: Step 3 can be skipped if the laser beam is already
activated.
4. Now aim the laser at the target point and press the MEAS
button briefly again to take a measurement. If the meas-
16
urement is successful, the measured result will be shown on
the bottom row
pushed upwards.
Note:
- Repeat the step 1 to 4 if needed to measure another distance.
- Distance Measurement mode icon
under single measurement mode.
- Maximum up to 4 measured values can be shown on the
display at a same time.
16
of the display. The previous readings are
23
to activate the laser. Once
will stay on (not flashing)
26
on
31
GB/IE 47