Installation Of The Quattro Control-Box; Connecting The Electric Appliances; Operation; Switching The Unit On - Renfert SILENT V4 Bedienungsanleitung

4.6.1 Installation of the Quattro Control-Box

Position the Quattro Control-Box so that the electrical appliances can be easily connected.
Power supply:
EN
Before connecting the electrical appliance, please ensure that the voltage information on the type
plate is compatible with the local power supply.
⇒ Insert the supplied power cable (18, Fig. 1) into the power connection at the QCB (17, Fig. 5).
⇒ Insert the power cable into the socket.
Connecting to the Silent V4:
⇒ Connect the QCB interface cable (10) to
QCB interface (12) on the extraction unit.
⇒ Connect the QCB interface cable (10) to the
connection point (20) of the Quattro Con-
trol-Box.

4.6.2 Connecting the Electric Appliances

⇒ Connect the electric appliances to the appliance socket connections (16, Fig. 5) on the QCB (A, B, C,
D). Observe the allocation of the socket connections – suction channel / pinch valve.
When connecting the electronic equipment to the Quattro Control-Box, ensure that the total sum
of currents from the connected electrical appliances does not exceed the maximum permissible
load on the Quattro Control-Box (see section 8.2, Technical Data).

5. Operation

The extractor unit is operated via the buttons on the key-pad (Fig. 2).
5.1

Switching the Unit On

The extractor is switched ON and OFF at the On / Off switch (3).
The switch on process takes place in the following steps:
Display firmware version

5.1.1 Stand-By

In the stand-by mode the display is dark.
Change to the stand-by mode:
• If no button has been pressed and no suction hose is open for a period of 2 min.
Leave stand-by mode:
• Press any button.
• To switch on one of the connected Quattro Control-Box appliances. Once switched on, the suction hose
will open immediately and the extractor turbine will activate.
Action / Result
MENU
Switch on
Filter cleaning A B
A B
Self diagnosis
Ready for use
Note
OFF
total
reset
On / off switch (3)
ON
Approximately 5 sec.
C display "Code 01" D
Duration approx. 20 sec.
C D
Once activated, approx. 30 sec.
- 10 -
12
10
20
resetdefault
ON ONOFF
OFF
Fig. 6
3
Fig. 7