Changing The Light Bulb - Everglades EVBI630 Handbuch

The food is too warm.
Interior lighting does not
work.
Heavy build-up of
possibly also on the door
seal.
Unusual noises.
The compressor does not
start immediately
changing the temperature
setting.
Water on the floor or storage
shelves.
Warning!
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or
the circuit breaker.
Light bulb data: 220-240V, max. 15 W
To switch off the appliance, set the temperature regulator to position "0".
Unplug the mains plug.
To change the light bulb, undo the screw.
Press the light bulb cover as shown and slide it backwards.
Change the defective light bulb.
Refit the light bulb cover and the screw.
Put the refrigerator back into operation.
Temperature
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
frost, Door seal is not air-tight(possibly
after reversing the door).
Appliance is not level.
The appliance is touching the wall
or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or the
wall.
This is normal, no error has
after occurred.
Water drain hole is blocked.

Changing the light bulb

is not properly
16
Please look in the "initial Start
Up" section.
Open the door only as long as
necessary.
Turn the temperature
regulation to a colder setting
temporarily.
Please look in the "installation
location" section.
Please look in the "changing
the Light Bulb "section.
Carefully warm the leaking
sections of the door seal with a
hair dryer(on a cool setting). At
the same time shape the
warmed door seal by hand
such that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
The compressor starts after a
period of time.
See the "cleaning and care"
section.