Specifications - Makita 906 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch
2-1. Wrench 17

SPECIFICATIONS

Max. wheel point diameter
Rated speed (n)/No load speed (n
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection.
Vibration
The vibration total
determined according to EN60745:
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
Explanation of general view
2-2. Wrench 10
2-3. Collet nut
Model
Collet size
)
0
Overall length
Net weight
Safety class
) : 78 dB(A)
pA
value (tri-axial vector
2
) : 5.0 m/s
h,SG
2
ENE050-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENF002-1
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
ENG104-1
machine(s):
Designation of Machine:
Die Grinder
Model No./ Type: 906
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
ENG207-2
And are manufactured in accordance with the following
standards or standardised documents:
sum)
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
ENG901-1
Milton Keynes, MK15 8JD, England
000230
3
5-1. Dressing stone
906
6 mm or 1/4"
19 mm
-1
25,000 min
283 mm
0.94 kg
/II
Corporation as the
30th January 2009
Tomoyasu Kato
Director
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, JAPAN
ENH101-12
responsible