Russell Hobbs 20770-56 Handbuch Seite 4

PREPARING THE FILTER CARTRIDGE
1. Twist the water tank lid anti clockwise and remove.
2. To remove a used filter cartridge, hold the tank firmly with one hand, grip the top of the filter
cartridge with the other hand and pull it up and out.
3. Remove all packaging from the new filter cartridge.
4. Don't worry if the inside of the packaging is damp – it's just condensation.
5. There might be black carbon particles in the packaging or on the filter cartridge. Don't worry, they're
harmless.
6. To ensure efficient operation, all air must be removed from the filter cartridge.
7. Submerge the filter cartridge in a bowl of cold water and shake it gently till no more bubbles are
released.
8. You may notice some black carbon particles floating in the water. Again, don't worry, they're harmless.
9. Before first use, you must flush the filter cartridge.
10. Push the filter cartridge into the funnel inside the reservoir till it won't go any further.
11. Fill the carafe to the mark and empty it into the tank. Repeat (there's no need to wait for the water to
filter through).
12. This will fill the coffee maker to the max capacity.
Press and release the e button. The e will show in the display.
13.
14. Shortly afterwards, water will start to drip into the carafe.
15. Discard the water, and repeat the operation.
16. When you've discarded two lots of water, the filter cartridge is ready for use.
RESET THE BRITA® MEMO
This shows what proportion of the filter cartridge's 4 week life is left.
1. Press and hold the START button till all 4 bars appear and flash twice, then let go.
2. Every week, one bar will disappear.
3. When all 4 bars disappear, a flashing arrow will appear at the top of the display. This means it's time to
replace the filter cartridge.
4. When the display gets down to one bar, it's a good idea to check that you've got another filter
cartridge available. If you haven't, it's time to buy some.
5. The flashing dot at the bottom right of the display shows that the Memo is working.
PREPARATION
1. Route the cable so it doesn't overhang, and can't be tripped over or caught.
2. Don't plug it in yet.
FILTER HOLDER
1. To remove, lift the filter holder handle upright and lift the holder up and out.
2. To replace, make sure the handle is upright (fig. A), and lower into the filter compartment.
3. Lower the handle until the hooks on the holder grip the pins in the compartment (fig. B).
FILLING
1. Twist the water tank lid anti clockwise and remove.
2. Remove the carafe from the hotplate.
3. Use the filling gauge printed on the carafe (
4. Replace the water tank lid and turn it clockwise to lock.
5. Open up a #4 paper filter, and put it into the filter holder.
6. Put 1 scoop of filter-ground coffee into the filter for each cup using the scoop provided.
7. Close the lid.
) to fill the reservoir.
t
4