Herunterladen Inhalt Inhalt Diese Seite drucken

Sanitization; Models Without Sanitization System; Models With Sanitization System; Using The Shower - Jacuzzi maxima Bedienung Und Wartung

Vorschau ausblenden Andere Handbücher für maxima:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 30
The individual colours:
- white;
- turquoise;
- green;
- orange;
- violet.
To move from one colour to the next, or to change the se-
quence, repeatedly press the
Where the water level in the tub is below that required for
hydromassage, the light will function at reduced power.
It is also possible to turn on the light when the tub is emp-
ty, using it as a courtesy light (the light will function at reduced
power in this context too).

Sanitization

We recommend the J-MX 07 liquid, offered by Jacuzzi and available
at the Assistance Centres/Authorised Retailers, is used to clean the
tub hydraulic circuit (approximately once a month dependent on
how often the hydromassage is used).
It is possible to carry out this cleaning operation using the same
water used for the hydromassage provided that soap, oils, cosmet-
ics,have not been used; otherwise, empty the tub and fill it once
again.
In any case, the tub water level (free of concentrates) must fully
cover the highest jets.

models without sanitization system

Check that the outlet nozzles are open (refer to the section,
"Recommendations").
Pour approximately 150 ml of J-MX 07 liquid into the tub.
Activate the hydromassage for just over 1 minute; leave the
liquid to act for at least a further 15 minutes.
Open the drain and empty the tub.

models with sanitization system

Pour the J-MX 07 liquid into the relevant tank (remove the
cover on the tub edge).
key.
Keep the keys presented held down simultaneously for a few
seconds: the pumps will activate and the sanitization cycle will
begin.
it is possible to activate the function from both of the control
panels.
The cycle is completely automatic and is characterised by the
activation and deactivation of the pumps; the sanitization cycle
lasts approximately 10 minutes. Approximately one minute from
the end of the cycle, the pumps are activated once again to rinse
the pipes.
The sanitization process cannot be interrupted unless the
power is disconnected via the main switch.

Using the shower

To remove the shower from the support, press the button
downwards.
Once you have finished using it, reposi-
tion the shower by pressing and releasing
the button.
19
2
1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis