Important Safety Information; Installation - Stell SHO 1160 Bedienungsanleitung

EN GENERAL INSTRUCTIONS FOR INSTALLATION

IMPORTANT SAFETY INFORMATION

• Check the content of the package in parts list on page 2 and make sure that all parts are in order. Do not
use damaged or faulty parts.
• Read all instructions before installing the equipment. When you are unsure about any part of the
installation process, ask a professional technician for help.
• When tightening the screws, be careful to avoid stripping the thread.
• Do not install on a damp or otherwise damaged wall. The assembly material supplied in the package is
designed to be mounted on a wall of bricks and concrete. For installation on walls made of other materials
consult a professional.
• Never install or use this product if there are signs of damage.
• The edges of the equipment may cause injury if they are handled improperly.
• This device is not designed for assembly or handling by small children, or persons, who have not been
speci cally instructed unless supervised by a responsible person to ensure safety during handling or
installation. Children should be supervised to ensure that they do not interfere with the equipment.
Do not allow children to hang on the equipment or otherwise handle it. Otherwise, there is a danger of
serious injury. Never insert your ngers or other objects into the mechanism of the equipment. It could
cause personal injuries or property damage.
• The product contains small parts that can pose a choking hazard when inhaled or swallowed. Keep these
parts out of reach of children!
Note: Speci cations and design are subject to change due to improvements without notice.
LIST OF SUPPLIED PARTS
A TV set brackets
B Wall holder
C Attachment
D Screw M4×12
E Screw M6×12

INSTALLATION

This TVG mount must be securely fastened to a vertical wall. If not solidly installed, it
could fall and cause injury or damage.
Installing the mount on the wall of solid brick or concrete wall or panel
Mark on the wall the position of two holes (upper and lower) for attaching the body of the holder. Use the
holder B as a template (Fig. 1). Use a spirit level to make sure the holes are horizontal. Use masonry drill
(10 mm) to pre-drill holes at least 9 cm deep and insert plastic anchor into each hole N. Check that the plastic
anchor is entirely inserted and even with the wall. (Fig. 2). Attach the holder to the wall using two screws M as
shown in Fig. 3.
Mounting of bracket on TV set
TV set with at rear wall (Fig. 4A)
First, nd the screws suitable for using on the TV set (D/E): try to screw them in manually in the holes on the
back of the TV set. If you feel resistance stop screwing in immediately! Once you nd the screw with the
correct threat proceed according to the drawing 4A. Insert matching washer on the screw (J/K) and then
screw it into the bracket A and nally in the TV set. Check if the brackets hold rm.
F Screw M6×10
G Screw M8×16
H Screw M4×30
I Screw M6×35
J Washer M4
12 – EN
K Washer M6
L Spacer M4/M6
M Screw M8×90
N Expansion plug M10×80
O Allen key