Description Of Controls-Mark Ii, Q-Style Washer-Extractor - Milnor Mark II Handbuch

Description of Controls—
Mark II, Q-Style Washer-Extractor
m/M
Master switch
This switch controls single-phase control circuit power to the machine and the DC power
supply for the microprocessor and its components. Setting this switch to m during
operation stops the machine.
a
Operator Signal
This signal is activated when operator attention is required, as when unloading is required
or certain errors occur. Pressing A cancels the signal.
A
Signal Cancel button
This button extinguishes the operator signal (a). If the signal was programmed as part
of a formula, the formula resumes after this button is pressed. If an error caused a to
illuminate, pressing A after correcting the error will extinguish the signal. If a was
illuminated when a valid formula was selected, the signal will terminate automatically
when the formula is started or the door is opened.
R/P
Run/Program keyswitch
Setting the keyswitch to R prevents programmed data from being changed and allows
normal machine operation. Setting the keyswitch to P allows programming machine
operation and certain troubleshooting procedures.
Emergency Stop button
No symbol
This large red button in a yellow rectangle may appear in several locations on the machine.
It performs the same function as 0, but locks in the depressed position and must be
turned to release the button and close the circuit before operation can resume.
2
MSOUPQCTAE/9433AV