Sony FW-85BZ35F Installationsanleitung Seite 14

C: portrait, no leaning / D: portrait, +20° leaning
You can only install FW-85BZ35F/FW-75BZ35F using the installation "C: Portrait, no leaning". The
installation "D: Portrait, +20° leaning" does not support FW-85BZ35F/FW-75BZ35F.
Step 1:
Checking the parts
required for the
installation
Follow Step 1 in the SU-WL500 instruction manual to
check the parts.
Step 2:
Deciding on the
installation location
Follow Step 2 in the SU-WL500 instruction manual to
decide on the installation location. Refer to page 20
of this manual for the monitor installation dimension
table.
Step 3:
Installing the Base
Bracket on the wall or
mounting
Follow Step 3 in the SU-WL500 instruction manual to
install the Base Bracket.
14
(GB)
Step 4:
Preparing for the
installation of the
monitor
1
Remove the stands if they are
installed to the monitor.
Be sure to lay down the monitor on a soft cloth
to protect the monitor. The installation of the
Mounting Hook is also done with the monitor
laid down.
FW-85BZ35F/FW-75BZ35F/FW-65BZ35F/FW-55BZ35F
FW-49BZ35F/FW-43BZ35F
When using an electric screwdriver, set the torque
setting to approximately 2 N·m {20 kgf·cm}.
Do not lift the Mounting Hook before the screws
(two screws each for left/right) are secured. This
may distort the Mounting Hook or the monitor
cabinet.