Connecting The Headphones To A Second Bluetooth ® Device - Silvercrest SBKP 1 A2 Bedienungsanleitung

Once the connection has been established, the LED will briefly flash twice
white every 3 seconds.
Please note, your communication device must support Bluetooth
4.0 to use all options.
If you come into range of the paired device with the headphones switched
on, a Bluetooth
You may need to approve the connection on the communication device.
Please refer to the instructions for use of the communication device on this
topic!
If you leave the range of your communication device with your headphones,
the LED will flash white once every 2 seconds. If the connection is not restored
within 5 minutes, the headphones will switch off.
The headphones may be manually switched off by holding the
button for 3 seconds until acous tic signal sounds and the LED goes out.
5
Connecting the headphones to a second
Bluetooth
The headphones may be connected to two Bluetooth
at the same time. If the headphones are already connected to a device, follow
the steps below to connect to the second device:
Activate multipoint mode by pressing and holding
Acoustic signal sounds. The first communication device (mobile phone or
computer) is disconnected.
Now connect to the second communication device via Bluetooth
headphones. Please refer to the notes in the instructions for your communi-
cation device. Select the entry „SBKP 1 A2" from the list of devices detected
by your computer or mobile. The second communication device is connected.
Briefly press
cation device is connected again. Now, both communication devices are
connected to the headphones simultaneously.
14 GB/IE/NI
connection will automatically be established.
®
device
®
button and acoustic signal sounds. The first communi-
8
Standard
®
communication devices
®
button for 2 seconds.
8
with the
®