Pressure Sensor - Philips sonicare FlexCare Platinum Bedienungsanleitung

Intensity levels per mode
- Low: 1 LED indicator light.
-
High: 3 LED indicator lights.
-
Note: to adjust the intensity level to the next higher or lower level, you can
press the + button to increase intensity or the - button to decrease intensity
at any time during the brushing cycle.

Pressure Sensor

A change in vibration (and a slight change in sound) alerts you when you
apply too much pressure while brushing. See chapter 'Features'.
- 1 yellow LED indicates a low charge.
- 3 green LEDs indicate a full charge.
Place the toothbrush on the charger to recharge it.
Note: To keep the battery fully charged at all times, you may keep your
Sonicare on the charger when not in use.
Features
Pressure Sensor
This Sonicare type comes with the Pressure Sensor feature activated.
To deactivate or reactivate the Pressure Sensor feature:
1 Place the handle with a brush head attached on the plugged-in
charger or sanitiser.
2 Press and hold the power on/off button and the mode button for
2 seconds.
, You hear 1 beep to indicate that the Pressure Sensor has been
You hear 2 beeps to indicate that the Pressure Sensor has been
,
35_020_9771_1_Book_Simp_A6_v1.indd 13
: 2 LED indicator lights.
ENGLISH
13
14/04/15 10:40