Take Care; Changing The Internal Light - Candy 60 COMBI Anleitung

with the instructions
given on the packets that
you buy.
Check contents of the
refrigerator at regular
intervals.
Clean and defrost your
refrigerator regularly.
Prepare fresh food for
freezing in small portions
to ensure rapid freezing.
Always choose high
quality fresh food and be
sure it is thoroughly clean
before you freeze it.
Wrap all foods in
aluminum foil or freezer
quality plastic bags and
make sure any air is
excluded.
Wrap frozen food when
you buy it and put it into
the freezer shortly.
Keep food for as short a
time as possible and
adhere to "Best Before",
"Use By" dates.
For more about storing, download the App and visit
"Tips & Hints".
ENERGY SAVING
For better energy saving we suggest:

Installing the appliance away from heat
sources and not exposed to direct
sunlight and in a well-ventilated room.

Avoid putting hot food into the
refrigerator to avoid increasing the
internal temperature and therefore
causing continuous functionalizing of
the compressor.

Do not excessively stuff foods so as to
ensure proper air circulation.

Defrost the appliance in case there is ice
to facilitate the transfer of cold.

In case of absence of electrical energy, it
is advisable to keep the refrigerator
door closed.

Open or keep the doors of the appliance
open as little as possible.

Avoid adjusting the setting to
temperatures too cold.

Remove dust present on the rear of the
appliance.

TAKE CARE

Defrosting
This appliance has automatic defrosting system, no
need to defrost by hand.
containing carbonated
liquids into the freezer
as they may burst.
Remove items from the
freezer with wet hands.
Freeze fizzy drinks.
Consume ice-cream and
water ices direct from
freezer. It may cause
"freezer burns" on lips.
Store poisonous or
dangerous substances in
the freezer.
Cleaning and Care
After defrosting you should clean the Fridge/Freezer
internally with a weak solution of bicarbonate of
soda. Then rinse with warm water using a damp
sponge or cloth and wipe dry. Wash the baskets in
warm soapy water and ensure they are completely
dry before replacing in the Fridge/Freezer.
Condensation will form on the back wall of the
Fridge; however it will normally run down the back
wall and into the drain hole behind the salad bin.
The drain hole will have a "cleaning spike" inserted
into it. This ensures that small pieces off food can
not enter the drain. After you have cleaned the
inside of your Fridge and removed any food residues
from around the whole, use the "cleaning spike" to
make sure that there are no blockages. Use standard
furniture polish to clean the Fridge/Freezer exterior.
Make sure that the doors are closed to prevent
polish getting on the magnetic door seal or inside.
The grille of the condenser at the back of the
Fridge/Freezer and the adjacent components can be
vacuumed using a soft brush attachment.
Do not use harsh cleaners, scouring pads or solvents
to clean any part of the Fridge/Freezer.

CHANGING THE INTERNAL LIGHT

1. Before carrying out the LED replacement
always disconnect the mains supply.
2. Hold and lift up the LED light cover.
3. Remove the old LED by unscrewing it in an
anti-clockwise direction.
4. Replace with a new LED light by screwing it in a
clockwise direction marking sure that it is
secure in the light holder.
5. Refit the light cover and re-connect your
Fridge to the mains supply and switch on.
REVERSING THE DOOR SWING
Dissemble the Refrigerator Door
1. a．Use a tool to remove the screw off the
hinge cover, and then remove the latter. Insert
the communication line to the hole on the
cabinet top.
b． Use a tool to remove the 4 screws off the
upper hinge cover and then remove the latter.
Pry up the door bush and small end cap cover
on the door.
c． Insert the door bush and door
communication line into the hole on the door
and then put on the small end cap cover.
d． Use a tool to remove the 2 screws as
shows in the below figure to remove the hole
cover on the cabinet top and get the cabinet
communication line out of the hole.
Pry up the small end cap cover on the door
and get out the door bush and door
communication line.
e． Insert the door bush into the round hole
on the door and then put on the small end cap
cover.
f． Move the refrigerator door upward over
23