Storage - Scheppach CSH58 Originalbetriebsanleitung

Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance
must be performed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly.
Failure to perform the prescribed maintenance work can lead to accidents! The user of the chain saw must not perform
maintenance work which is not described in the instruction manual.
All other work may only be performed by a specialist workshop.
General Chain saw
Saw chain
Chain brake
Guide bar
Before each start Saw chain
Guide bar
Chain lubrication
Chain brake
OFF switch, Safety locking
button, Throttle lever
Fuel/ oil tank cup
Every day Air filter
Guide bar
Guide bar support
Idle speed
Every week Fan housing
Cylinder space
Spark plug
Muffler
Spark arrester screen
Chain catch sleeve
Screws and nuts
Every 3 months Fuel filter
Fuel, oil tank

Storage

Chain saw
Guide bar/ chain
Fuel, oil tank
Carburretor
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the following parts are
therefore also required for use as consumables.
Wear parts*: Saw chain, Guide bar, Saw chain oil, Engine oil, Spiked
filter, saw chain oil filter
* Not necessarily included in the scope of delivery!
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Clean exterior, check for damage. In case of damage have
repaired by a qualified service center immediately
Sharpen regulary, replace in good time
Have inspected regularly at an authorized service center
Turn over to ensure even wear of bearing surfaces
Replace in good time
Inspect for damage and sharpness
Check chain tension
Check for damage
Functional check
Functional check
Functional check
Check for tightness and leckage
Clean
Check for damage, clean oil intake bore
Clean, in particular the oil guide groove
Check (chain must not run)
Clean to ensure proper air cooling
Clean
Check and replace if necessary
Check tightness of mounting
Clean
Check for damage, replace if necessary.
Check their condition and that they are firmly secured.
Replace
Clean
Clean exterior, check for damage. In case of damage, have
repaired by a qualified service center immediately
Demount, clean and oil slightly
Clean the guide groove of the guide bar
Empty and clean
Run empty
bumper, Chain catcher, Spark plug, air filter, fuel
GB 47