Working Position - Riello RC2R Montage- Und Bedienungsanleitung

To adjust delivery, proceed as follows:
loosen screw (7) and adjust the ring (8),
➤
turning it to the desired setting;
secure in place by tightening screw (7) with
➤
a driving torque of 0.8 Nm.
BAFFLE PLATE (see fig. 6)
The baffle plate is installed whenever the burner's
purging performance needs increasing. This compo-
nent is supplied separately.
To install this fitting, you must:
unscrew the three screws (9, fig. 2 page 3) and
➤
remove the air adjustment unit (5);
apply the baffle plate (10) by means of the two
➤
screws (11), screwing it on with a driving torque of
0.8 Nm;
follow the above procedure in the reverse order,
➤
restoring the feeder (5) to its original position, tight-
ening the two screws (9) with a driving torque not
exceeding 0.8 Nm;
make extra sure you position the O-ring (12) cor-
➤
rectly.
3. INSTALLATION
THE BURNER MUST BE INSTALLED IN CONFORMITY WITH LEGISLATION AND LOCAL STANDARDS.

3.1 WORKING POSITION

The burner is designed to work only in the positions 1, 2 and 3.
Any other position could compromise the correct working of the appliance.
Installations 4 and 5 are forbidden for safety reasons.
1
2902936
Fig. 5
(CF and BF version)
2
4
D7011
Fig. 6
12
3 4
GB
A
8
7
6
5
11
10
D7013
5
D7003