Technical Data; Battery Pack - FLORABEST FARM 40-Li A1 Bedienungs- Und Sicherheitshinweise

Technical data

Q
Cordless
lawnmower:
Rated voltage:
No load speed n :
0
Cutting width:
Cutting heights:
Grass catcher volume: 40 l
Dimensions (H x W x D): (1010 - 1190) x 475 x
Weight (incl. accessories):15.5 kg
Protection class:
Degree of protection:

Battery pack:

Type:
Rated voltage:
Capacity:
Number of cells:
Rapid battery
charger:
Input
Rated voltage:
Power consumption:
Output
Rated voltage:
Charging current:
Charging time:
Protection class:
Noise emission value:
Noise measurement value determined in
accordance with EN 60335. The A-rated noise
level of the power tool is typically as follows:
Sound pressure level L
pA
Uncertainty K :
pA
Sound power level L :
WA
Uncertainty K :
WA
Guaranteed sound power
level L :
WA
(according to 2000/14/EC amended by
2005/88/EC)
8 GB
FARM 40-Li A1
40 V
3700 min
-1
430 mm
25/35/45/55/65/75 mm
(1140 - 1350) mm
III /
IPX1
FAP 40 A1
Lithium ion
36 V
40 V max.
2.5 Ah (90 Wh)
10
FLG 40 A1
200 – 240 V ~ ,
50 / 60 Hz
160 W
36 V
3.6 A
approx. 60 min
II /
: 81.0 dB(A)
3 dB
94.3 dB(A)
1.81 dB
96 dB(A)
WARNING!
Wear ear protection!
Vibration emission value:
Total vibration values (vector total of three
directions) determined in accordance with
EN 60335:
Hand/arm vibration a : 2.81 m/s
h
Uncertainty K:
WARNING!
The vibration level varies in accordance
u
with the use of the power tool and may
be higher than the value specified in these
instructions in some cases. There is a risk of
underestimation of the vibration load if the
power tool is used regularly in this manner.
Try to keep the vibration loads as low as
possible. Measures to reduce the vibration
load are, e. g. wearing gloves and limiting
the working time. Wherein all states of
operation must be included (e. g. times when
the power tool is switched off and times
where the power tool is switched on but
running without load).
NOTE
The vibration level specified in these
u
instructions has been measured in
accordance with a standardised measuring
procedure specified in EN 60335 and can
be used to make equipment comparisons.
The specified vibration emission value can
also be used to make an initial exposure
estimate.
2
1.5 m/s
2