Vacuum Extraction Of Dust / Debris; Connecting A Vacuum Dust Extraction Device; Selecting The Right Tool - Parkside PMFW 280 A2 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Assembly
per minute. This means the tool can produce precise
work in the tightest of spaces.
Sawing / cutting:
Use only undamaged, defect-free saw blades.
Distorted, blunt or otherwise damaged saw
blades could break.
When sawing lightweight building materials,
observe the statutory requirements and the
manufacturer's recommendations.
Use the device in plunge sawing mode on soft
materials such as wood, gypsum plaster board
etc. only!
Sanding:
Ensure that you use even contact pressure. This
will increase sanding sheet life.
Assembly
Q
Vacuum extraction of
Q
dust / debris
Do not use the tool on materials containing asbestos.
Asbestos is a known carcinogen.
DANGER oF FIRE! There is
the danger of fire when working with electrical
devices that have a dust box or can be connected
to a vacuum cleaner. Under certain conditions the
wood dust in the dust extraction bag (or in the vac-
uum's dust bag) may ignite, e.g. as a result of flying
sparks generated when abrading metals or metal
objects left in wood. This can happen particularly if
the wood dust is mixed with paint residue or other
chemicals and the abraded particles are hot from
prolonged abrasion. Therefore you must empty the
device's dust collection box and the vacuum clean-
er's dust bag before taking a break or stopping
work and always avoid overheating of the abrad-
ed particles and the device.
Wear a dust mask!
Always use vacuum dust extraction.
Ensure that your working area is well ventilated.
40 GB/MT
Observe the regulations applicable in your
country for the materials you are working on.
Connecting a vacuum
Q
dust extraction device
Push the housing attachment
extraction duct , ring connector
13 b
Place the vacuum dust extraction assembly
on to the device (see Fig. H).
Slide the hose of a suitable dust extraction
device approved for that purpose (e.g. a work-
shop vacuum cleaner) on to the adapter for ex-
ternal vacuum extraction with the reducer piece,
if used.

Selecting the right tool

Q
Plunge saw blade (20 mm)
Materials:
Sheet and tube up to approx. 3 mm made of
aluminium, copper
Use:
· Cutting and trimming to length of tube and sheet
(see Figs. J)
Plunge saw blade (32 mm)
Materials:
Wood, plastic, plasterboard and other soft materials
Use:
· Cutting and plunge sawing
, vacuum dust
13 a
together.
13 c
13
5
6