Changing The Attached Tool; Place A Sanding Sheet On The Backing Plate; Vacuum Extraction Of Dust / Debris; Connecting A Vacuum Dust Extraction Device - Parkside PMFW 280 A1 Betriebsanleitung

· Close to the edge sawing, even in difficult to
access areas
Example: Laying parquet and other floor coverings,
including plunge sawing.
Scraping knife
9
Materials: Mortar / concrete residues, tile / carpet
adhesives, paint / silicone residues
Use:
· Removal of material residues, for example tile
adhesive when replacing damaged tiles
©

Changing the attached tool

WARNING! DANGER OF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.
Remove any tool already inserted. To do this,
release the clamping screw
key and take off the tool.
11
Place the tool (e.g. plunge saw blade
the tool mount.
NOTE: You can place the tool in any of the
possible positions on the tool mount.
Fasten the tool in place with the clamping
screw and clamping plate
10
clamping screw
10
½
Check that the tool is firmly seated.
Incorrectly or insecurely attached tools could
become lose during use and injure you.
using the Allen
10
) on
6
. Tighten the
4
using the Allen key .
11
©
Place a sanding sheet
on the backing plate
Offer up the sanding sheet
one side of the backing plate
the sanding sheet to the backing plate.
©
Vacuum extraction of
dust / debris
Do not use the tool on materials containing asbestos.
Asbestos is a known carcinogen.
DANGER OF FIRE! There is
WARNING!
the danger of fire when working with electrical
devices that have a dust box or can be connected
to a vacuum cleaner. Under certain conditions the
wood dust in the dust extraction bag (or in the vac-
uum's dust bag) may ignite, e.g. as a result of flying
sparks generated when abrading metals or metal
objects left in wood. This can happen particularly if
the wood dust is mixed with paint residue or other
chemicals and the abraded particles are hot from
prolonged abrasion. Therefore you must empty the
device's dust collection box and the vacuum clean-
er's dust bag before taking a break or stopping
work and always avoid overheating of the abrad-
ed particles and the device.
Wear a dust mask!
Always use vacuum dust extraction.
Ensure that your working area is well ventilated.
Observe the regulations applicable in your
country for the materials you are working on.
©
Connecting a vacuum
dust extraction device
Push the housing attachment
extraction duct , ring connector
13 b
Place the vacuum dust extraction assembly
on to the device (see Fig. H).
Slide the hose of a suitable dust extraction
device approved for that purpose (e.g. a work-
Assembly
to fit flushly on
12
, then apply
7
, vacuum dust
13 a
together.
13 c
13
GB/IE 11