Makita CL183D Bedienungsanleitung Seite 8

Reassembly
► Fig.9: 1. Prefilter 2. Filter
First, put filter without being peeled back. If filter is put
on incorrectly, dust will get into motor housing, and
cause motor failure. Second, put prefilter over filter.
► Fig.10: 1. Securing lip
Turn the set of filters, and adjust the position of the two
securing lips on prefilter, and connect with the gutters of
the cleaner housing.
► Fig.11: 1. Alignment marks
► Fig.12: 1. Handle 2. Capsule
Connect capsule, in accordance with alignment marks
on handle and capsule, firmly twist capsule in direction
of arrow until it is secured.
NOTE:
• Always remove dust ahead of time, as suction power
will be reduced if there is too much dust in cleaner.
• Always be sure to check that both filter and pre-
filter are loaded correctly prior to using cleaner.
If they are not loaded correctly, dust will get into
the motor housing, and cause motor failure.
OPERATION
CAUTION:
• Insert (or extract) nozzle while twisting it clock-
wise. If twisted counterclockwise, capsule may
become loose.
► Fig.13: 1. Capsule
Cleaning (Suction)
Nozzle
► Fig.14: 1. Nozzle
Attach the nozzle to clean off tables, desks, furniture,
etc. Nozzle slips on easily.
Nozzle + Extension wand (Straight pipe)
► Fig.15: 1. Cleaner body 2. Extension wand
3. Nozzle
The extension wand fits in between the nozzle and the
cleaner itself. This arrangement is convenient for clean-
ing a floor while standing erect.
Things to Check Before Asking for Repairs
Symptom
Weak suction power
Not working
Area to be investigated
Is capsule full of dust?
Is filter clogged?
Is battery exhausted?
Is battery exhausted?
Corner nozzle
► Fig.16: 1. Corner nozzle 2. Cleaner body
Fit on the corner nozzle for cleaning corners and crev-
ices of a car or furniture.
Corner nozzle +Extension wand
(Straight pipe)
► Fig.17: 1. Corner nozzle 2. Extension wand
3. Cleaner body
In tight quarters where the cleaner itself cannot
squeeze in, or in high places hard to reach, use this
arrangement.
Cleaning without nozzle
► Fig.18
You can pick up powder and dust without nozzle.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off
before attempting to perform inspection or
maintenance.
Cleaning
► Fig.19
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening, dust bag/dust pack
mounting area and the dust stopper.
CAUTION:
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
► Fig.20
Wash the filter in soapy water when it is clogged with
dust and the cleaner power becomes small. Dry it out
thoroughly before use. An insufficiently dried filter may
cause poor suction and shorten the service life of the
motor.
Do not blow dust sticking on the cleaner by air duster. It
brings dust into the housing and causes failure.
Fixing method
Empty dust from capsule.
Dust down or wash filter.
Recharge battery.
Recharge battery.
8 ENGLISH