Using The Machine; End Of Use And Switching Off - RCM BIT 391CB Gebrauch Und Wartung

EN
9.1.c -

Using the machine

- After having started the machine and se-
lected the type of cycle, start the cleaning
operation by pressing the levers (8) and
holding them pressed to start rotation of
the brush and the dispensing of water,
then push the machine by means of the
handles (10) in the handle bar (11).
N.B.:
Releasing the levers (8) stops the rotation of
the brush and the dispensing of water.
N.B.:
To avoid damaging the floor, do not use the
machine in a fixed position with brush rota-
tion activated
N.B.:
The correct way of cleaning and drying the
floor is to move the machine forwards. Mov-
ing the machine backwards damages the
blades as well as not allowing correct aspira-
tion of the water present on the floor.
- If necessary, adjust the quantity of wash-
ing water using the tap (12).
- Check the status of the battery charge by
the indicator (5) (only on version CB).
9.1.d - End of use and switching off
- Once cleaning is complete, before switch-
ing off the machine, halt the water supply
and brush rotation by releasing the levers
(8), then continue with the aspirator acti-
vated to aspirate all the liquid present on
the floor, then switch off the aspirator by
pressing the button (7) and switch off the
machine by positioning the button (4) on
"0".
- Raise the squeegee (13) by pulling the le-
ver (6) and releasing it, the lever remains
in an upper position thus maintaining the
floor wipers in the raised position.
7
8
6
13
EN-16
5
4
11
12
Fig. 12
8
10