Adjusting The Inclination; Adjusting The Height Of The Belts And The Headrest; Adjusting The Child Car Seat Buckle; Removing 5-Point Seat Belts - Chicco Seat Up 210 Gebrauchsanleitung

and seating your child, remove the car seat's
integrated 5-point belts making reference to
paragraph 12. REMOVING 5-POINT SEAT BELTS
Position the child car seat on the selected seat.
WARNING! Make sure there are no objects
between the child car seat and the vehicle
seat or between the child car seat and car
door.
WARNING! The back of the child car seat
must closely adhere to the car seat.
Adjust the headrest to the highest posi-
tion (refer to paragraph 10. ADJUSTING THE
HEIGHT OF THE BELTS AND THE HEADREST)
Place the child in the seat with their back lean-
ing against the backrest.
Insert the diagonal portion of the car seat belt
in the red diagonal belt guide integrated in
the headrest (B) (Fig. 34).
Pass the abdominal part through the red belt
guide on the seat on the side of the retractor
(Fig. 35). Continue to fit the seat by inserting the
diagonal and abdominal part of the belt in the
red belt guide, on the side of the buckle, fasten-
ing the belt until you hear a CLICK (Fig. 36)
Adjust the height of the headrest so that the
red diagonal belt guide (B) is above the child's
shoulders at a maximum distance of 2 cm (fig.
37).
Pull the diagonal part of the belt upwards (Fig.
38) so the entire belt is taut and fits closely
over the child's legs and chest without being
too tight!
WARNING! Check that the car seat belt ad-
juster is reclined or at least aligned with the
car seat backrest (Fig. 39).
WARNING! In case of use in vehicles equip-
ped with rear seat belts with integrated ai-
rbags (inflatable belts) follow the vehicle ma-
nufacturer's instructions.

9. ADJUSTING THE INCLINATION

To adjust the inclination of the child car seat,
pull the lever located under the seat (H) to-
wards you. When the Gr. 0+ (0-13 kg) child
seat is fitted, it must be adjusted to the maxi-
mum recline position.
In Gr. 1 (9-18 kg) and Gr. 2 (15-25 kg) the car
seat can be adjusted to 3 different positions
(Fig. 40).
10. ADJUSTING THE HEIGHT OF THE
BELTS AND THE HEADREST
The height of the headrest and belts can be
simultaneously adjusted using the headrest
and belt adjustment button (A) (Fig. 41).
To increase the height of the headrest release
the safety belts by pressing button F and, at
the same time, hold the two child car seat
harnesses under the shoulder straps and pull
them towards you. Then lift button A.
To lower the headrest press button A.
To adjust them correctly, the headrest must
be fitted so the harnesses come out from the
backrest at the height of the child's shoulders
(Fig. 42).
11. ADJUSTING THE CHILD CAR SEAT
BUCKLE
The child car seat buckle can be adjusted to
two different positions: A and B.
• Position A: use for Gr. 0+ (from 0 up to 13
kg) and Gr. 1 (9-18 kg).
• Position B: use for Gr. 2 (15-25 kg).
The buckle is in position A when purchased.
When the car seat is used for Gr. 2 (15-25 kg) it
is necessary to switch to position B.
Remove the padded crotch strap (I). Turn the
metal connector and switch from position A
to position B (Fig. 43). After this check that the
belt has not rolled up. Pull the buckle several
times to check it is inserted correctly. After ad-
justing, replace the padded crotch strap.

12. REMOVING 5-POINT SEAT BELTS

Loosen the 5-point seat belts as much as pos-
sible using button F.
Adjust the headrest to its maximum height
using the headrest and belts adjustment but-
ton (A).
Turn the child car seat so you are looking at
the back of the seat.
Remove the two belts from the metal connec-
tor (Fig. 44).
Position the metal connector in its specific slot
(Fig. 45).
Open the cover, remove the shoulder straps,
separating them by pressing on the connect-
ing ring (Fig. 46).
Remove the belts and take off the shoulder
29