Emos P5613 Bedienungsanleitung Seite 5

The Original Thermostat Replacement
ATTENTION: before replacing the thermostat, disconnect the heating / air conditioning system from the main source of
electric voltage in your apartment. Hence you will prevent a possible electric shock. Before disconnecting the electric
cables, read carefully the following instructions:
1. Switch off the original thermostat and remove the thermostat's cover.
2. Unscrew the thermostat from the wall plate.
3. Unscrew the connecting back plate from the wall. Draw the back plate a small distance away from the wall, however,
do not disconnect any wires so far.
Press carefully the lock of the front cover and withdraw it.
Marking the Wires
1. Identify each wire and disconnect it.
2. Protect the wires against the possible pull out.
3. Avoid any air penetration by using the poly-urethane foam, in case the space behind the thermostat is too large.
Thus you will prevent the incorrect temperature measuring.
Testing the Wireless Communication between Units
1. By the thumb-wheel set the room temperature about a few degrees higher than is the current room temperature,
confirm by pressing OK. Set the AUTO mode on the switching unit.
2. Wait a few seconds.
3. The upper LED will light up on the switching unit.
4. If the LED does not light up, move the control unit closer to the switching unit. By the thumb-wheel set the room
temperature lower than is the room temperature – the receiver must shut down and the LED will not be on.
5. Repeat the steps 1 to 4. The transmission range between the control unit and switching unit is 60 m in an open area.
The range may be shorter indoor due to the signal interference caused by walls and other obstacles.
6. After carrying out the test press on the switching unit the RESET button.
Control Unit (Transmitter) Display
5