Emos P5613 Bedienungsanleitung Seite 11

Anti-Freeze Function
This system function enables to set the constant temperature of 5 °C.
By the thumb-wheel select the snow flake icon and press OK.
By the thumb-wheel set the earlier start ON or OFF.
By pressing OK you will return to the main menu.
You can combine this function with the Holiday mode.
In this case it is not possible to set a different temperature but 5 °C.
Thermostat Setting Tolerance
1. Thermostat hysteresis setting (dF)
2. Thermostat delay setting (dL)
3. Thermostat's surrounding temperature calibration (TP)
By the thumb-wheel select the SET icon (setting) and press OK.
Thermostat Hysteresis Setting (dF)
Hysteresis is a temperature difference between the intervals, heating ON and heating OFF modes. E. g. when you set
the temperature to 20 °C, variance to 0.5 °C, the heater starts working and when the room temperature falls down to
19.5 °C and switches off when the temperature reaches 20,5 °C.
By the thumb-wheel select the (dF) icon and press the thumb-wheel.
By the thumb-wheel set the hysteresis in the range of 0.5 – 2 °C, in 0.5 °C steps,
confirm by pressing OK and hence you will again access the preset mode.
To return to menu press OK again.
Thermostat Delay Setting (dL)
This function will delay the start about 5 minutes.
11