Operation; Technical Data - Bresser 8831000 Bedienungsanleitung

OVERVIEW
B Operating button for seconds
C Operating button for counting
D Battery compartment (A: cover, B: batteries used)
E Display (A-E: display variations)
F Spirit level
G Control button for setting
H Compass control button
I °F/°C toggling control button
J Storage pouch

OPERATION

Stopwatch
Press the seconds control button () on the top just once to activate the stopwatch (A)
mode. The stopwatch can then be started by depressing the seconds control button
again. The timer can be interrupted or continued by depressing this button again. Press
the count button () to stop the timer and reset the display to zero. Press the set button
(6) to leave the stopwatch mode and revert to the standard mode (B).
Time
Hold the set button (6) down to switch to the watch setting mode. Press the count
button () to increase either hours or minutes by one. Depress the set button
once to move on to the next input field. Finally, keep the set button depressed to
confirm your input and leave this menu.
Compass
Press the compass button (7) to switch to the compass mode (D). Keep this
button depressed to get to the calibration mode. In this menu all the arrows blink
and <CAL> is shown in the centre of the display (C). Once it's shown hold the

compass flat in your hand and turn it twice clockwise. Then briefly press the
compass button. If <OP> or <0°> is shown press the compass button. <0°>
stands for north here. Then press the compass button again to leave this menu
and finalise compass calibration.
Thermometer
Press the F/°C button (8) in standard mode (B) to toggle between Centigrade
and Fahrenheit.
Changing the battery
Open the battery compartment on the back of the compass (3A) and insert a
LR03 (AAA, Micro) battery in the holder. Make sure the battery polarity is correct
- align the + pole (3B)! Then close the compartment cover.

TEChNICAL DATA

Digital compass
Precision +/- 3°
Time
-hour format
Display hh; mm; ss
Stopwatch
Precision /0 s
Display mm; ss
Thermometer
Precision +/- °
Optional display of °Fahrenheit or °Centigrade
Operating temperature -0 to + °C