General; Tools Required For Installation (Not Supplied); Accessories Supplied With Unit; Type Of Copper Tube And Insulation Material - Panasonic R410A Einbauanleitung / Betriebsanleitung

1. GENERAL

This booklet briefly outlines where and how to install the
air conditioning system. Please read over the entire set of
instructions for the indoor and outdoor units and make sure all
accessory parts listed are with the system before beginning.

1-1. Tools Required for Installation (not supplied)

1. Flathead screwdriver
2. Phillips head screwdriver
3. Knife or wire stripper
4. Tape measure
5. Carpenter's level
6. Sabre saw or key hole saw
7. Hack saw
8. Core bits
9. Hammer
10. Drill
11. Tube cutter
12. Tube flaring tool
13. Torque wrench
14. Adjustable wrench
15. Reamer (for deburring)

1-2. Accessories Supplied with Unit

See Table 1-1.
Table
1-1 Ceiling

1-3. Type of Copper Tube and Insulation Material

If you wish to purchase these materials separately from a local
source, you will need:
1. Deoxidized annealed copper tube for refrigerant tubing.
2. Foamed polyethylene insulation for copper tubes as
required to precise length of tubing. Wall thickness of the
insulation should be not less than 8 mm.
3. Use insulated copper wire for field wiring. Wire size varies
with the total length of wiring. Refer to 4. ELECTRICAL
WIRING for details.
CAUTION
Check local electrical codes and regulations before
obtaining wire. Also, check any specified instructions or
limitations.

1-4. Additional Materials Required for Installation

1. Refrigeration (armored) tape
2. Insulated staples or clamps for connecting wire (See your
local codes.)
3. Putty
4. Refrigeration tubing lubricant
5. Clamps or saddles to secure refrigerant tubing
6. Scale for weighing
Type
Table 1-1 (Ceiling)
Part Name Figure
Special
washer
Drain
insulator
T5
Flare insulator
Insulating
White
tape
(heat-
resisting)
Vinyl clamp
Eyelet
Full-scale
installation
diagram
Drain hose
L140
Hose band
5
Q'ty Remarks
For temporarily
4 suspending indoor unit
from ceiling
T10
1 For drain hose joint
T3
2 For gas and liquid tube
sets joints
For gas and liquid flare
2
joints
For flare and drain
8 insulator (Field supply
for Spanish version)
1 For power supply inlet
1 Printed on container box
For main unit + PVC
1
pipe joints
For drain hose
2
connection