Introduction; Proper Use; Features And Equipment - Parkside PWS 230 Bedienungs- Und Sicherheitshinweise

Introduction

The following pictogrammes / symbols are used in these operating instructions:
Read the operating instructions!
Always heed warning labels and
safety instructions!
Caution - Danger of electric shock! Hazardous
voltage – danger to life!
Explosive material!
Risk of fire!
V ~
Volt (AC)
n
Rated idle running speed
0
Angle grinder PWS 230
Introduction
Q
Please make sure you familiarise yourself
fully with the way the device works
before you use it for the first time and
that you understand how to handle electrical pow-
er tools correctly. To help you do this please read
the accompanying operating instructions. Keep
these instructions in a safe place. If you pass the
device on to anyone else, please ensure that you
also pass on all the documentation.

Proper use

Q
The device is intended for the dry cutting, rough
grinding and brushing of metal and stone. Any other
use or modification to the device shall be considered
as improper use and could give rise to considerable
dangers. We will not accept liability for loss or
6 GB/IE/CY
W
Watts (effective power)
Protection category II power tool;
double insulated
Wear hearing protection, dust protection mask,
protective glasses and protective gloves.
Keep children and other unauthorised personnel
at a safe distance when using electrical tools.
Keep the device away from rain or moisture.
Water entering an electrical device increases the
risk of electric shock.
Damaged appliances, power cables and power
plugs mean potentially fatal risks from electric
shock. Regularly check the condition of the appli-
ance, the power cables and the power plugs.
Dispose packaging and appliance in an
environmentally-friendly way!
damage arising from improper use. The device is
not intended for commercial use.

Features and equipment

Q
Hand grip (rotatable)
1
ON / OFF switch
2
Safety lock-out
3
Unlocking button
4
Carbon brushes cover
5
Auxiliary handle
6
Disc guard cover
7
Clamping lever
8
Coded projection
9
Adjuster screw
10
Spindle lock button
11
Threaded hole (3 x) for auxiliary handle
12
Clamping nut
13
Mounting spindle
14
Mounting flange
15
Coded groove
16
Spanner
17