Description; Purpose; Overview; Safety - GreenWorks GD40BV Bedienungshandbuch

EN
1

DESCRIPTION

1.1

PURPOSE

The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard. Some
machines also suck in leaves and small twigs through a
vacuum, and shred them into a bag.
1.2

OVERVIEW

Figure 1 - 13.
Speed dial
1
Speed button
2
On/off button
3
Blower tube
4
Gate
5
Auxiliary handle
6
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine
before use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2

ASSEMBLE AS A MULCHER

Figure 2 - 8.
Mulcher tube
7
Collection bag
8
Lock button
9
Slot
10
Notched area
11
WARNING
WARNING
WARNING
English
Make sure that the machine is in the OFF position,
and the impellers stop before you attach or remove
tubes.
1. Move the front and rear mulcher tubes together until
the lock button engages.
2. Pull the lock button forward to disengage the gate.
3. Hold the gate open.
4. Put the "wedged" end clip of the mulcher tube into
the rear clip.
5. Push the "hooked" end clip of the mulcher tube into
the front clip.
6. Push back the lock button to engage the mulcher
tubes.
You can do the steps above in the opposite sequence
to remove the mulcher tubes.
7. Put the bag adaptor into the blower outlet. Lock the
bag adaptor with the lock button.
It can be necessary to remove the blower tube or
mulcher tubes to clean a blocked tube or impeller.
3.3

ASSEMBLE AS A BLOWER

Figure 9.
1. Move the blower tube forward until the notched area
clicks into the slot.
3.4

INSTALL THE BATTERY PACK

Figure 10.
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.5

REMOVE THE BATTERY PACK

Figure 10.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4
WARNING
TIP
NOTE
WARNING