Maintenance - RIB MAGIC-Serie Bedienungsanleitung

G
B
S
AFETY CLUTCH ADJUSTMENT
Lift the cover of the box to reveal the adjuster screw of the mechanical
clutch located on top of the speed reducer casing (Fig. 14).
Remove the black protective cap, release the lock nut, and rotate the
screw clockwise to increase the force transmitted by the motor to the
gate.
The adjustment should be made in such a way as to obtain a force
marginally greater than that effectively required to set the gate in motion.
N.B.: More force you set on the motor clutch, less reversibility you
obtain from the operator.
M
AINTENANCE
To be undertaken by specialized staff after disconnecting power
supply.
- Make certain that moving parts located inside the box are greased once
a year, and check the force transmitted through the drive to the gate.
- The motor should be overhauled every two years and the oil replaced.
In the event that the need for servicing or repairs should arise, the
speed reducer can be removed from the box without taking down the
gate.
- Lift the cover from the box, isolate the motor from the power supply by
disconnecting the cable, then remove the curved lever: the gate can
now swing freely.
- Thereafter, loosen the four nuts which secure the fixing plate to the box
and serve to clamp the speed reducer in position (Fig.15-A/B).
E
LECTRICAL SAFETY DEVICES
The installation must be installed according to the current regulations
and laws. Use the T2 (for one or two single-phase motors) electronic
control unit. For connections and technical data of accessories refer to
the appropriate booklets.
ACCESSORIES -
T
2
code ABT2000 => CRX 230/50-60HZ
code ABT2001 => 230/50-60HZ
code ABT2002 => CRX 120/60HZ
code ABT2003 => 120/60HZ
Automatic travel and timing code learning system
Pedestrian opening command
Pedestrian and total automatic closure
Pre-blinking
Adjustable slow speed in approaching
Electronic adjustment of the force
Radio command - step by step or automatic total opening
Radio command - step by step or automatic pedestrian opening
Single command - step by step or automatic
Electric lock release operation
Built-in radio receiver 433MHz
Management of the photocells
Automatic closing after the transit through the photocell
Management of the blinker
Management of the strips
Safety strip autotest as required by EN12453
Key selector
Buzzer
Electric lock
For the connections and the technical data of the optional equipments follow the relevant
handbooks.
T
2 Wi-Fi
With MASTER Wi-Fi card.
code ABT2001W
26
26
14
15