Clock Programming According To Haccp; Switching On - Nordcap Project Line Gebrauchs- Und Wartungshandbuch

24 - EN

7.2 CLOCk PROGRAMMING ACCORDING TO HACCP

When machine is off, press simultaneously for extended time buttons
DISPLAY1 indicates the last figure of the year
DISPLAY2 indicates the letters "Year".
Pressing the button
year
By pressing the
Exit from the clock menu occurs automatically after 60 seconds or by pressing the

7.3.0. SWITCHING ON

By pressing the
No selection is visible in DISPLAY 1 (Fig.1).
DISPLAY 2 indicates the cabinet temperature.
(Fig.1)
7.3.0.1 PRECOOLING
After having selected a blast chilling or freezing cycle (even already executed), pressing the button
PreCooling cycle that takes the room temperature to:
-10°C if a blast chilling cycle has been selected
-25°C if a freezing cycle has been selected
If no cycle has been selected previously, the room behaves as if a freezing cycle has been selected.
Once the PreCooling SetPoint has been reached, the Buzzer sounds for 3 seconds every 60 seconds to indicate that
the room is ready to execute the blast chilling cycle.
During the PreCooling cycle:
DISPLAY 2 shows the temperature of the room.
The symbols ,
At the start of the compressor and fan, the respective symbols
Opening the door or pressing the button
and
mounth
to confirm the value entered and pass on to the next value.
button the board switches on.
and or are lit.
the user can modify respectively:
day
are also lit.
interrupts the cycle, and the card reproposes the last cycle selected.
( +3°C) and
hour minutes
.
button.
activates a